Seating and Positioning

PAMS Universal Lockable Joint

Overview

This is a low-cost 3D printable joint to be used for mounting assistive technology. The joint allows for 1/2 inch PVC pipes to be inserted in and allow movement in all degrees of freedom. This device is intended to work with other PAMS mounting devices to allow adjustable and lockable positioning in all directions.

Usage

The PVC is inserted into the lockable joint and then positioned in the desired location. Once the optimal mounting location is found the joint is locked in place by turning the handle of the device. This locks all the directions of the device. The joint can be repositioned by loosening the handle and tightening once again.

There is an optional larger handle that can be 3D printed as well. This version is better for individuals with reduced grip strength and allows more area to grab onto. If you are requesting this device and want to try out the larger handle please include that in the details of the request.

Build Instructions

Build instructions and design files can be found within the GitHub repository on this device page.

SKILLS REQUIRED

  • 3D Printing
  • Fine motor skills – Twisting bolt into place
  • Gripping – Using tools

TOOLS

  • Mallet/Hammer (optional)

COMPONENTS

  • 1x – M10 x 70 Hex Bolt  – Link
  • 1x – M10 Hex Nut – Link
  • 1x – M10 Flat Washer – Link
  • 1x – Rubber Washer – Link

3D PRINTING

All Components can be printed with no support at 20% infill with a 0.2 layer height.

  • 1x – Joint Handle
  • 1x – Left half of shell housing
  • 1x – Right half of shell housing

Attribution

University of Alberta Capstone Team:

  • Matthew Brydges
  • Bobby Li
  • Stanley Lim
  • Miguel Oliveira
  • Marco Villegas

Flag Bracket for Scooter

This flag bracket enables a flag to be mounted to an adult scooter to increase visibility to pedestrians and cars.

The flag bracket was designed for a GoGo Pride Mobility Scooter, which has a 0.8 inch square tube. A pair of brackets are used to attach the flag. Each bracket is attached to the tube using two #10 screws and nuts.

The top bracket should be drilled to the shaft diameter of the flag to provide a loose fit. The bottom bracket should be drilled halfway through. The flag shaft is then inserted through the top bracket and rests inside the bottom bracket.

Bill of Materials

To assemble the mount with the switch, you will need:
2 – 3D Printed Flag Brackets (~7 g of filament, $0.70)

4 – #10 Hex nut, lock nut, or acorn nut ($0.80 – $2.00)

4 – #10 Machine screws or bolts, 1-3/8″ or 1-1/2″ length ($2.80)

1 – Flag attached to shaft