Viewing 1 post (of 1 total)
  • Author
    Posts
  • #14713

    One-Handed Adapter for Joy-Con – Left

    picture of blue and red joycons connected by green 3D printed controller adaptation. Size Medium.

     

    MMC Library Link: https://makersmakingchange.com/project/one-handed-adapter-for-joy-con-left/

     

    Overview

    This 3D printed device allows for Nintendo Switch Joy-Cons to be held comfortably in a user’s left hand. The Joy-Cons can be easily slid in and out of the 3D printed modification and are set at an angle at which an individual can use the device with only a left hand. To allow differences in hand sizes there are small, medium, and large versions of the 3D print. However, this does not change the length of the print but only the angle at which the Joy-Cons are set. If you are requesting this device and know that you have a smaller or larger hand size, make a note of that in the request details. If you are not sure what size of this device is right for you, start at the medium size and evaluate from there.

    This 3D print is intended to be used in the user’s left hand, but a right-handed version of this device can be found here.

    Usage

    To use this device take the attachment side of the Joy-Con and slide it into the slot on the 3D print. Make sure that the Joy-Cons are inserted into the 3D print with the buttons facing outward. Place the left hand under the now mounted Joy-Cons and get familiar with the layout. Alternatively, one can place the mounted Joy-Cons on the table and the user can use their left hand on top of the controllers to play a game. Once the Joy-Cons are placed in the 3D print, the Nintendo Switch can then be turned on and used to play games or watch media.

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.