This is a low-cost 3D printable joint to be used for mounting assistive technology. The joint allows for 1/2 inch PVC pipes to be inserted in and allow movement in all degrees of freedom. This device is intended to work with other PAMS mounting devices to allow adjustable and lockable positioning in all directions.
The PVC is inserted into the lockable joint and then positioned in the desired location. Once the optimal mounting location is found the joint is locked in place by turning the handle of the device. This locks all the directions of the device. The joint can be repositioned by loosening the handle and tightening once again.
Viewing 1 post (of 1 total)
You must be logged in to reply to this topic.
Collaborate with makers in the community to develop your device idea.