• This topic is empty.
Viewing 12 posts - 1 through 12 (of 12 total)
  • Author
    Posts
  • #8308
    @

    Requestor: @garysuydam
    ______________________________________________________________________________________________________________________________
    Message:
    I don’t know if this is the correct project title or not, I have a lip sync and the plastic base that connects to the C clamp has just broken. It is the piece that touches the table and is held in place but the C clamp, and of lip sync arm attaches to it.
    Thanks

    MMC Entry .I.D: 6312

    #8309

    Hi @garysuydam,

    Is this the part?
    ![image|690×398](upload://w5hREzylm3xgFvm1kpcE5YiJig0.jpeg)

    If you have someone who can install it for you, I’d be glad to print it in PETG and ship from Alabama.

    #8310

    @creationstation3d is also close by. User is not in forum yet-I will reach out to invite.

    #8311

    Hello we would love to help! We are leaving cated in Colorado Springs. I will message @garysuydam

    #8312



    @garysuydam

    I’m unable to send @garysuydam a message. Is there another way to contact the person? Thanks

    #8313

    Christopher,
    Sorry I didn’t check the forum sooner. The picture you added is the correct! I see Dakota also responded so please coordinate so only one of you do it.
    Thank you so much.
    Gary

    #8314

    @creationstation3d It’s your call! I’d be glad to print and ship, but it sounds like you’re nearby.

    #8315

    Thanks we will coordinate with him!

    #8316

    @garysuydam I printed up two mounts for you. I sent you a message for your contact info.

    #8317

    Hi @creationstation3d and @garysuydam! Just checking in to see how the request is going.

    #8318

    Gary has been taken care of. Currently still working with him on any other items that he may need.

    #8319

    Hi,
    With Dakota’s help I was able to get up and running again.
    Thanks for all the help!
    Gary

Viewing 12 posts - 1 through 12 (of 12 total)
  • You must be logged in to reply to this topic.