3 Inch AT Switch Camera Mount
Setup & instructions
This is an inexpensive 3d printed mounting adapter to attach larger commercial assistive switches to camera-type mounts designed by ATMakers. This adapter should work with the following AbleNet switches:
- Jelly Bean Twist
- LITTLE Step-by-Step
- LITTLE Step-by-Step with Levels
- LITTLE Step-by-Step Choice with Levels
- LITTLE Step-by-Step GamePlay
- iTalk 2
- iTalk 2 with Levels
This mounting adapter also works with the Interact Switch from our assistive devices library.
The switch is connected to the mounting adapter using three screws. The mounting adapter can then be attached to a tripod or a mounting arm with a camera connection (i.e., 1/4″-20 UNC) to provide convenient switch placement.
A comprehensive set of instructions for creating this style of switch mounting adapter is available at the following link: http://atmakers.org/2017/02/at-switch-adapters/
Bill of Materials
To assemble the mount with the switch, you will need:
1 – 1/4″-20 UNC tee nut, 5/16″ , 7/16″, or 9/16″ long (~$0.30, hardware store or McMaster-Carr)
1 – 3D Printed Mounting Adapter, design file to match length of tee nut (~ 30 g of filament, $0.90)
3 – #6-32 UNC x 3/4″ long Machine screws
You will also need the following temporarily to install the tee nut:
1 – 1/4″ Washer
1 – 1/4-20 UNC machine screw or bolt, 3/4″ – 1-1/2″ length
1- Screwdriver, drill or wrench (depending on the type of bolt chosen) to tighten the bolt.
The mounting adapter is designed to be printed with support. The print should be oriented so that the cylindrical portion of the tee nut is vertical, with the large oval surface on the print bed.
Assembling the Mounting Adapter
Clean out any support material from the center section.
To install the tee nut, line up the barbs of the tee nut with the slots on the mount adapter. Put the washer on the 1/4″-20 UNC bolt, and thread it through the adapter and into the tee nut. Tighten the bolt until the tee is flush with the bottom of the adapter. You can then unscrew and remove the bolt and washer.
This video demonstrates how to install the tee-nut: https://youtu.be/_fH-vgqx3uw?t=2235
Attaching Mount To Switch
Attach the 3d printed mounting adapter to the back side of the switch using the three machine screws.
No reviews yet
Are you a device user or Disability Professional? Review this device!