This is an inexpensive 3d printed mounting adapter for connecting a commercially available Adaptivation Honeybee Proximity switch (https://www.adaptivation.com/product-page/honeybee) to camera-type mounts. This adapter was designed by ATMakers.
The Honeybee Proximity switch is slid inside the mounting adapter. The mounting adapter can then be attached to a tripod or a mounting arm with a camera connection (i.e., 1/4″-20 UNC) to provide convenient switch placement.
A comprehensive set of instructions for creating this style of switch mounting adapter is available at the following link: http://atmakers.org/2017/02/at-switch-adapters/
Bill of Materials
To assemble the mount with the switch, you will need:
1 – 1/4″-20 UNC tee nut, 5/16″ , 7/16″, or 9/16″ long (~$0.30, hardware store or McMaster-Carr)
1 – 3D Printed Mounting Adapter, design file to match length of tee nut (~ 70 g of filament, $0.80)
You will also need the following temporarily to install the tee nut:
1 – 1/4″ Washer
1 – 1/4-20 UNC machine screw or bolt, 3/4″ – 1-1/2″ length
1- Screwdriver, drill or wrench (depending on the type of bolt chosen) to tighten the bolt.
The mounting adapter is designed to be printed with the in the vertical orientation with the camera mount oriented horizontally.
Assembling the Mounting Adapter
Clean out any support material from the center section.
To install the tee nut, line up the barbs of the tee nut with the slots on the mount adapter. Put the washer on the 1/4″-20 UNC bolt, and thread it through the adapter and into the tee nut. Tighten the bolt until the tee is flush with the bottom of the adapter. You can then unscrew and remove the bolt and washer.
This video demonstrates how to install the tee-nut: https://youtu.be/_fH-vgqx3uw?t=2235
Attaching Mount To Switch
Slide the Honeybee Proximity Switch into the 3d printed camera mount adapter. Friction will keep it in place.