Flipper the Clipper
Setup & instructions
Mobility / Physical
$0 - $10
Aids for Daily Living (ADL)
Attribution-NonCommercial-ShareAlike 4.0 International
Flipper the clipper is an assistive device for one handed nail clipping. This 3D printed devices folds flat and has notches for a standard nail clipper to sit in.
To use this device, first place a nail clipper onto the device notches. Hold the rounded end and lift the device off the table surface, causing the device to “flip.” Rest the device on a flat surface and start clipping.
Approximately $0.75 CAD for filament.
Flipper the Clipper consists of a single 3D printed part. No assembly is required.
- 3D Printing
- 3D Printing Time: 2:15
- Assembly Time: 0
Designed by Nisker_ (Thingiverse) and remixed from SONOKO